RPGWatch Forums - View Single Post - (Gothic 1) Switches won't work in Sleeper Temple.
View Single Post


February 4th, 2012, 03:24
Google is your friend Somebody else had this problem and asked on Steam Gothic forum. The answer was:

"They're supposed to rotate back like that after you use them. To figure out the correct combination to use, go out into the main room with the two gated archways. There's a stone plaque between them with those same colors printed on it, and I'm pretty sure it tells you the order if you read them from left to right.

It's possible that the combinations you think you're using are off. IE, the game may only register a combination after every 3rd turn. So if you turned two stones arbitrarily then tried to do the correct combination, it might not register that as the combo. I'm just guessing here though I don't know if this is the case.

Either way, if you do the combo that's printed on the plaque, and perhaps try it again a few times, you should get through.

If all else fails, you can easily cheat your way through the gates by activating Marvin mode, and pressing K. (open the character stats screen, type in marvin, then close the character screen.)"
zahratustra is offline




Join Date: Jan 2008
Posts: 4,446